|Air Handling Capacity||3000CFM/ 85Nm3/min (Continuous Flow)|
|Maximum Working Pressure||30Bar / 3.0MPa|
|Aftercooler Performance||Reduction of Temperature from 80.C to 40.C|
|Power Requirements||220VAC, 50Hz|
|Inlet / Outlet Flange Size||6", 300#, RF Flange|
|Air Handling Hoses||2", 600psi, MNPT Threaded|
|Skid Framing||3100 x 1700 x 2500mm x 3MT|
|No of Units||2|
The aftercooler is attached between the compressor manifold and the regen dryer.
The primary function is to:
- Remove heat from the air content
- Remove oil content from the air moisture
The oil/water separator is made up of EX proof pressure vessel with carbon 3-5mm granules and lows continuous air to flow through it. It removes the oily moisture content in the air and purges the water out from beneath via a 1/2" piping. Purging time is time controlled via a timer solenoid valve every 10 minutes.